FAO index page AG index page
Print this page | Close

Slaughtering Process


In many developing countries, lack of appropriate slaughtering facilities and unsatisfactory slaughtering techniques are causing unnecessary losses of meat as well as valuable by-products from animal carcasses. Therefore adequate facilities, clearly defined working procedures and well-trained skilled labour are essential to guarantee a safe supply of wholesome meat.

 

Slaughter process diagram

 

process iter

 

In cattle slaughter commonly mechanical stunning (penetrative and non-penetrative) with a captive bolt pistol is used. Electrical stunning is increasingly an option. This is followed by bleeding in a hanging position. In smaller operations, the carcass is lowered onto a cradle, head and feet are removed and flaying (removal of skin) initiated. Then the carcass is raised again and flaying completed. In bigger operations, carcasses remain suspended on overhead rails and hide pulling devices are used to reduce contamination of the carcass surface. After flaying, evisceration takes place. White and red offal are separated, inspected and cleaned. Condemned material is separated and disposed of in a sanitary manner. The slaughter procedure for small ruminants is similar to that of cattle.

 

Poultry slaughter in larger operations, the birds are suspended by the leg on solid wire shackles attached to a conveyor system taking them to the various workstations. The birds are stunned prior to bleeding and then passed through either scalding water or a steam tunnel and through rotating devices with rubber scrubbers to remove feathers. After chilling the birds in iced water, evisceration takes place. In smaller operations, the birds are usually fixed in cones for bleeding, scalded in hot water and defeathered either manually or by use of a drum plucker. They are then eviscerated and chilled.

 

In pig slaughter electrical stunning is commonly used (carbon dioxide gas is an option). In smaller operations, the pig is hoisted for bleeding. After bleeding, the carcass is lowered into the scalding tank filled with water at around +60°C (140°F). After a few minutes, the carcass is removed and the hair is scraped off manually. After dehairing, the carcass is usually exposed to open gas flames to remove remaining hair and reduce surface contamination. The carcass is then transferred to the overhead rail where final cleaning takes place, followed by evisceration. The internal organs are inspected and cleaned for further use. The carcass is split and inspected and either chilled or directly dispatched. In larger operations pigs move on conveyor systems through scalding tunnels and dehairing machines with rotating rubber fixtures.