Manuals and Guides - BOBP/MAG/14 Building a liftable propulsion
by |
FOOD AND AGRICULTURE ORGANIZATION OF THE UNITED NATIONS BAY OF BENGAL PROGRAMME Madras, India 1993 |
The designations employed and the presentation of material in this publication do not imply the expression of any opinion whatsoever on the part of the Food and Agriculture Organization of the United Nations concerning the legal status of any country, territory, city or area or of its authorities, or concerning the delimitation of its frontiers or boundaries. |
All rights reserved. Reproduction and dissemination of material in this information product for educational or other non-commercial purposes are authorized without any prior written permission from the copyright holders provided the source is fully acknowledged. Reproduction of material in this information product for resale or other commercial purposes is prohibited without written permission of the copyright holders. Applications for such permission should be addressed to the Chief, Publishing and Multimedia Service, Information Division, FAO, Viale delle Terme di Caracalla, 00100 Rome, Italy or by email to [email protected]
© FAO 2004
Motorization of small fishing craft has contributed considerably to fisheries development in the Bay of Bengal region over the last few decades. In Indonesia. Thailand and Bangladesh the most common engines by far for small fishing craft, are the 5 - 15 hp range of multipurpose diesel engines used for water pumps, generators, power tillers and small tractors. The advantages of this type of engine, compared with the specially marinized diesel engine, is the low cost and easy availability of both engines and spare paris. Two methods for the installation of these engines have been developed and widely introduced. The conventional inboard installation, where the propeller shall is fitted through the keel structure, is used in boats operating from harbours or sheltered beaches. In the ‘longtail’ installation, the engine Sits on top of the transom and the propeller shaft goes through a long tube to the propeller. These two methods of installations are, however, not suitable for boats that have to land on surf-beaten beaches. |
INTRODUCTION
LIST OF MATERIALS